Motortopia: Where your passion parks

Motortopia: Where your passion parks.

Why Join Motortopia? So you can keep up with events... RSVP! Post Event Photos! Submit Events!

  1. cars
  2. bikes
  3. boats
  4. planes

Boats > CrimsonKrush’s Garage > Blog > Cutlass Work pt4

 

CrimsonKrush’s Profile Photo

CrimsonKrush

M –41
Richmond, Kentucky
United States

 

Advertisement

Cutlass Work pt4

Apr 10, 2007 | Views: 210

By CrimsonKrush

Share this story

Well got the 3.8 button'd up, dropped in and fired up since my last post. Sounds good and strong too. Going to be working on replacing the trans filter and pan gasket. Then dump some fluids in and hope it works. This 200-r4 that I put back in has been sitting around for about 3 years so its a gamble I'll have to take. It worked when I took it out but that doesnt mean anything with transmissions. Finally got my mig welder and have been playing around with that. The big project is yet to come with cutting the lower rear qtrs off the parts car and grafting them to the Salon. After that I can worry about the cosmetics of the body and engine compartment.

Permanent Link to this Blog Post:

Log in to post comments.

Read comments on this blog post

No comments have been posted on this blog post.

Advertisement

Advertisement

 

Boats > CrimsonKrush’s Garage > Blog > Cutlass Work pt4

Print your passion at Motortopia.com (http://www.motortopia.com)