Cars > CrimsonKrush’s Garage > Blog > Welding,Welding and more... welding

CrimsonKrush

M –41
Richmond, Kentucky
United States

view full garage

Blog Categories

CrimsonKrush’s Garage

CrimsonKrush’s Blog Posts 1 – 5 of 13

Welding,Welding and more... welding: Fri Mar 21, 2008 | comment
Just a hack: Sun Mar 2, 2008 | comment
What a year: Mon Dec 31, 2007 | comment
Cutlass Work pt5: Thu May 31, 2007 | comment
Cutlass Work pt4: Tue Apr 10, 2007 | comment

newer posts older posts

Welding,Welding and more... welding

Mar 21, 2008 | Views: 154

By CrimsonKrush

Share this story

Well I finished channeling the other side of the frame, the passenger rear. Also went to ACE Hardware for some washers and welded those back in the three body mounts that were shot. Now I'm boxing the open 'C' section of the frame (added pics to the 'featured' album). Couldnt find any 4 inch wide steel so I had to settle for 3 inch and bent the lower lip of the frame up to fill the gap. Actually think this is a better route to go and may make the area more ridgid than just welding a piece in without the bend. Anyway should have this done this weekend which will leave the only thing left to do is clean and paint (POR-15) it. Pretty happy with how things are moving along. Just have to keep plugging along one step at a time.

Permanent Link to this Blog Post:

Read comments on this blog post

No comments have been posted on this blog post.