Motortopia: Where your passion parks

Motortopia: Where your passion parks.

Why Join Motortopia? So you can keep up with events... RSVP! Post Event Photos! Submit Events!

  1. cars
  2. bikes
  3. boats
  4. planes

Cars > Challenges > “Charo” Vs “"Ashley"”

 

LowRanchero’s Profile Photo

LowRanchero

M–56
Panama City, Florida
United States

CorvairJim’s Profile Photo

CorvairJim

M–51
Norristown, Pennsylvania
United States

 

1965 Ford Ranchero

“Charo”

1966 Chevrolet Corvair Monza

“"Ashley"”

 
Photo of: 1965 Ford Ranchero
Photo of: 1966 Chevrolet Corvair
 

Head to Head

 

About “Charo”

I acquired this car in 2002 at a swap meet in Moultrie, Georgia. When I purchased it the car had a fuel injected 92’ Mustang GT roller motor. Unfortunately, I have very little patience when it comes to modern electronics so after a few months out the door the injection system went in favor of the old reliable Holley 650 carburetor with an Edelbrock intake. Of course nothing ever goes as planned when dealing with older cars and I ran into several issues. I had to take the AOD transmission out and replace it with a C-4, I tried to use the injected type fuel pump with a regulator without success and had to replace the exhaust from the mufflers forward. The car was quite a bit quicker injected than it is carbureted but I’m working on that. I plan to install a Thumper cam and have the heads reworked very soon. I also plan on raising the car up about 2 inches (it’s just too low for me) and changing out the dated Centerlines. Because of the chopped top, lowering and so forth, I get a lot of “what kind of car is it” comments when I take the old Ranchero out for a walk. I haven’t heard one negative comment about the car to date.

About “"Ashley"”

Back in 2000, I had the misfortune to have to take a prescription that meant I couldn't drive. I sold the daily car I had at that point (one plain-Jane black 5-speed Cavalier coupe - a transportation appliance at best). A couple of years went by, and I changed doctors. The new guy prescribed something different for my condition, so I needed wheels once again. I could: A) spend $4,500 on a cheap used car that would just blend into the woodwork or, B) Find a really decent Corvair set up the way I like it. Now THAT car doesn't blend in. I found this '66 Corvair in Denver, CO, on eBay. The engine had been rebuilt by a nationally-known Corvair specialist shortly before the previous owner put it into storage for about ten years. It came out of the rebuild capable of putting 220 horsepower down to the pavement. Not bad for 164 unblown, carbureted cubic inches! It also had new tires all around. I won the auction, and flew out with my wife to drive it home. A fantastic road trip, and it cost half as much as shipping it would have. It became my daily driver for the next three years, until, in late '05, I had it in for state inspection at a friends Corvair restoration shop. While it was up on the lift, I got to see just how little rust the car had underneath. I decided at that point that it had seen its last winter of Pennsylvania road salt! It is now my nice spring day car, and a pleasure to drive. It still draws attention wherever I go with it.

UPDATE: I had to sell my beloved Ashley in August of 2009 due to the nation's lousy economy. My overtime had gone away and and my wife lost her job due to a work-related disability that they refused to accept responsibility for, so we just couldn't justify the expense of nearly $100/month to insure the third car in a two-driver household. Our mortgage was a couple of months behind, so sadly I took a friend up on his standing offer on her. As promised, he has given her the complete cosmetic restoration she so badly deserved. Of course, she didn't need anything mechanically - I always kept her up 100% mechanically. Furthermore, he gave me right of first refusal, so if he should ever decide to sell her, I get the first opportunity to buy her back.

 

Specs for “Charo”

2" chop
93' Mustang GT motor
Extremely low (oil pan is 4" off ground)
Tubbed
Shaved door handles

Specs for “"Ashley"”

1966 Corvair Monza Sport Coupe
164 C.I.D. Opposed 6-cylinder engine, air cooled.
Lemonwood Yellow paint, Black interior

 

Factory Options for “Charo”

Unknown

Factory Options for “"Ashley"”

(All options verified by build sheet)
140 horsepower, 4 carb engine
4-speed transaxle
Posi rear
Sport Suspension
"Mag-Style" full wheel covers
AM pushbutton radio

 

Mods for “Charo”

To many to list

Mods for “"Ashley"”

Engine rebuilt to Yenko Stinger Stage III specs - 220 net horsepower.
Suspension lowered 1 coil.
Gas shocks
Steering Dampener
Low-restriction intake and exhaust.
Full window tint.
Tail panel painted silver (like the factory did with the Corvair Corsa model).
AM/FM/CD/Stereo unit mounted under the dash - NO holes cut or drilled for the installation!
Additional gauges (Tachometer, Voltmeter, Oil Pressure, Oil Temperature)
Pennsylvania Vanity Plate "CORVA1R"

 

Photo Albums 1 – 1 of 1

Cover photo of 65' Ranchero album
65' Ranchero
Photos: 11
 

Previous Photo Albums Next Photo Albums

Photo Albums 1 – 2 of 5

 

Previous Photo Albums Next Albums

 

Vote This challenge has ended!

Points for Charo Total Votes Points for "Ashley"
40 16 40

 

Comments on this challenge 1 – 9 of 9

Log in to post comments.

Read comments on this challenge (1 – 9 of 9)

Log in to view challenge comments.

Download Drive Magazine Now!

Advertisements

    Special Offers & Deals

Advertisement

 

Cars > Challenges > “Charo” Vs “"Ashley"”

Print your passion at Motortopia.com (http://www.motortopia.com)