>

Motortopia: Where your passion parks.

Motortopia > Drive! > MCP-WOR-1103-PERT-PIX-15 > MCP-WOR-1103-PERT-PIX-15

 

Advertisement

Advertisement

MCP-WOR-1103-PERT-PIX-15 » MCP-WOR-1103-PERT-PIX-15

When the distributor is dropped into place, it was a few degrees off. It’s possible to use a long flat-bladed screwdriver to slightly spin the drive gear in order to get the rotor to line up properly.

When the distributor is dropped into place, it was a few degrees off. It’s possible to use a long flat-bladed screwdriver to slightly spin the drive gear in order to get the rotor to line up properly.

It takes a little finesse, but getting the new Pertronix billet distributor into place isn’t difficult. Note that due to the teeth on the gear, the shaft/rotor will spin as it drops, so you have to take that into consideration when it’s installed.
A specially designed wrench makes it easier to get the hold-down tightened properly. A good idea is to inspect the hold down to make sure that it is in good shape.

This entry was posted on Friday, January 7th, 2011 at 12:59 pm and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Comment

You must be logged in to post a comment.