>

Motortopia: Where your passion parks.

Motortopia > Drive! > Articles > Tech > Replacing Mustang Fender Sheet Metal > DRV-1103-RRCFNDR-PIX-31

 

Advertisement

Advertisement

Replacing Mustang Fender Sheet Metal » DRV-1103-RRCFNDR-PIX-31

After a rough trimming, the panel is wrestled into place. One thing to remember, this thing is unwieldy and sharp, so care is taken.

After a rough trimming, the panel is wrestled into place. One thing to remember, this thing is unwieldy and sharp, so care is taken.

The panel is rough-cut to get it close to the proper size, but a little extra material is left on it. The extra will be trimmed off precisely as needed. Holes are also punched into various edges, such as beneath the wheel opening, so spot welds can be placed.
The panel is carefully fit, and Clecko pins are used to hold it in place.

This entry was posted on Tuesday, April 12th, 2011 at 10:19 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Comment

You must be logged in to post a comment.