>

Motortopia: Where your passion parks.

Motortopia > Drive! > Articles > Tech > WEEKEND UPDATE > Drive-1008-Weekend_07

 

Advertisement

Advertisement

WEEKEND UPDATE » Drive-1008-Weekend_07

7 Sealant is applied to the gaskets and to the ports, then allowed to get tacky before being slipped over the posts.

7 Sealant is applied to the gaskets and to the ports, then allowed to get tacky before being slipped over the posts.

6 Posts are place in the upper holes of the water pump ports and will act as supports for the main housing during installation. They only need to be "finger tight" since they will be removed shortly.
8 The lower pulley and the tensioner are installed. Note that the tensioner bolts securely to the block. A few drops of thread-locking material on the bolts couldn't hurt, either.

This entry was posted on Wednesday, September 1st, 2010 at 4:05 pm and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Comment

You must be logged in to post a comment.