Motortopia: Where your passion parks.

Motortopia > Muscle Car Power > TECH > A Magna Charger 6.2L Supercharger Kit Makes It Simple > MCP-1104-MAGNUSON-PIX-10

 

Advertisement

Advertisement

Advertisement

A Magna Charger 6.2L Supercharger Kit Makes It Simple » MCP-1104-MAGNUSON-PIX-10

Remove the harmonic balancer main bolt and install the supplied drill guide (using a 24mm socket and torque wrench set to 30 ft-lb), a use the small 3/8-inch drill with the supplied drill bit and suitable cutting oil to drill two guide holes to the second step of the drill bit. Remove the guide and clean and ream the holes (with the supplied reamer).

Remove the harmonic balancer main bolt and install the supplied drill guide (using a 24mm socket and torque wrench set to 30 ft-lb), a use the small 3/8-inch drill with the supplied drill bit and suitable cutting oil to drill two guide holes to the second step of the drill bit. Remove the guide and clean and ream the holes (with the supplied reamer).

Unbolt and remove the fan shroud assembly. Set it aside for later reinstallation.
Remove the drive belt by loosening the tensioner pulley bolt. Then remove the oil pressure sensor from the valley cover and set aside for later use.

This entry was posted on Monday, May 2nd, 2011 at 11:27 pm and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Comment

You must be logged in to post a comment.