Motortopia: Where your passion parks.

Motortopia > Muscle Car Power > TECH > Grounded Impala Installing Air Ride on Your Classic Chevy > MCP-0903-LOW-03

 

Advertisement

Advertisement

Advertisement

Grounded Impala Installing Air Ride on Your Classic Chevy » MCP-0903-LOW-03

Brackets for mounting the valves are made from 1/8-inch steel. The holes are offset to one side in order to allow the other side to be welded to the car’s frame. Measure out the holes and hit them with a punch to be drilled.

Brackets for mounting the valves are made from 1/8-inch steel. The holes are offset to one side in order to allow the other side to be welded to the car’s frame. Measure out the holes and hit them with a punch to be drilled.

Loctite is applied to each fitting before it is screwed into the valve. Don’t forget to wipe off the excess Loctite afterwards.
The holes are drilled out and the bracket is cut and ground smooth on a chop saw. You can use the finished bracket as a template for the next bracket.

This entry was posted on Wednesday, June 9th, 2010 at 10:12 pm and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Comment

You must be logged in to post a comment.