Motortopia: Where your passion parks.

Motortopia > Muscle Car Power > TECH > Installing a Pertronix Flame-Thrower/Ignitor III Ignition System > MCP-WOR-1103-PERT-PIX-14

 

Advertisement

Advertisement

Advertisement


Installing a Pertronix Flame-Thrower/Ignitor III Ignition System » MCP-WOR-1103-PERT-PIX-14

It takes a little finesse, but getting the new Pertronix billet distributor into place isn’t difficult. Note that due to the teeth on the gear, the shaft/rotor will spin as it drops, so you have to take that into consideration when it’s installed.

It takes a little finesse, but getting the new Pertronix billet distributor into place isn’t difficult. Note that due to the teeth on the gear, the shaft/rotor will spin as it drops, so you have to take that into consideration when it’s installed.


Leave a Comment

You must be logged in to post a comment.