Motortopia: Where your passion parks.

Motortopia > Muscle Car Power > TECH > Installing a Pertronix Flame-Thrower/Ignitor III Ignition System > MCP-WOR-1103-PERT-PIX-15

 

Advertisement

Advertisement

Advertisement


Installing a Pertronix Flame-Thrower/Ignitor III Ignition System » MCP-WOR-1103-PERT-PIX-15

When the distributor is dropped into place, it was a few degrees off. It’s possible to use a long flat-bladed screwdriver to slightly spin the drive gear in order to get the rotor to line up properly.

When the distributor is dropped into place, it was a few degrees off. It’s possible to use a long flat-bladed screwdriver to slightly spin the drive gear in order to get the rotor to line up properly.


Leave a Comment

You must be logged in to post a comment.