Motortopia: Where your passion parks.

Motortopia > Muscle Car Power > TECH > Installing a Pertronix Flame-Thrower/Ignitor III Ignition System > MCP-WOR-1103-PERT-PIX-26

 

Advertisement

Advertisement

Advertisement


Installing a Pertronix Flame-Thrower/Ignitor III Ignition System » MCP-WOR-1103-PERT-PIX-26

The next step is to slide the rubber boot over the end. Lange uses a pair of needle nose pliers to loosen up the rubber a little. It’s a good trick for you at home, just don’t get carried away and poke a hole somewhere.

The next step is to slide the rubber boot over the end. Lange uses a pair of needle nose pliers to loosen up the rubber a little. It’s a good trick for you at home, just don’t get carried away and poke a hole somewhere.


Leave a Comment

You must be logged in to post a comment.