NASCAR88’s Profile Photo


Bridgeport, Pennsylvania
United States

racerx23’s Profile Photo


Dallas, Georgia
United States


2007 Chevrolet Monte Carlo SS (with the "Dale Earnhardt" look)

“The Intimidator”

1983 Mitsubishi pickup mustang spanker !!!

“get summ”

Photo of: 2007 Chevrolet Monte Carlo SS
Photo of: 1983 Mitsubishi pickup

Head to Head


About “The Intimidator”

I saw one of these cars on the road and decided then and there that I had to have one. I found out there was a "Dale, Jr. Edition" too, but I like the look of the black and silver combination better than the red and silver. The blue and silver "Jeff Gordon Edition"? Who cares?

About “get summ”

I built this truck about 15 years ago.I love to street race it.I used to race at the Dallas Dragstrip here in Dallas,Ga.until after 50 years they closed it. Now it mostly gets a few runs up the road and back.Can't go too far @ $9.00 a gallon for fuel. Real ground pounder !! We raced it in the Pinks All Out race at the Atlanta Dragway in May.We ran .006 seconds too fast @10.24 in the 1/4 mile.They picked a class of 16 cars that ran 10.30 in the 1/4 mile.Oh well we had a great time !!!!


Specs for “The Intimidator”

Small-block V-8 and front wheel drive. It'll smoke 'em all the way down the block!

Specs for “get summ”

The engine is a stroker small block chevy.The engine dynoed @ 612 HP (without NOS) The truck will pull the front end,and does run consistant 6.60s on motor.The truck has run in the high 5.80s on the bottle! It will run faster with someone else ,who cares to work on it.( I'm bored with it).


Factory Options for “The Intimidator”

It came pretty much loaded, with heated leather seats and XM Stereo.

Factory Options for “get summ”

paint ??


Mods for “The Intimidator”

K&N Low-Restriction intake system, chip, Borla cat-back exhaust.

Mods for “get summ”

stroker sbc.less than 400 CI. 13.5 to 1 compression, dynoes @ 612 HP.on motor.I have'nt dynoed on either NOS kits.I run a 2 speed glide w/ trans brake and a 5500 stall convertor,4:86 rearend w/ full strange spool and 33 spline axles,The motor internals are all Lunati.The heads are AFR.aluminum 2.12 intake,Torker intake,Holley Dominator flowing 1194 cfm. custom headers and 3" Flow Master exhaust. Truck still has stock suspenion in front and rear.


Photo Albums 1 – 1 of 1

Cover photo of "The Intimidator" album
"The Intimidator"
Photos: 5

Previous Photo Albums Next Photo Albums

Photo Albums 1 – 1 of 1

Cover photo of get summ album
get summ
Photos: 16

Previous Photo Albums Next Photo Albums


Vote This challenge has ended!

Points for The Intimidator Total Votes Points for get summ
50 16 30


Comments on this challenge 1 – 7 of 7

Log in to post comments.

Read comments on this challenge (1 – 7 of 7)

Log in to view challenge comments.