Photo 1 of 2:
<< first photo < prev next > last photo >> Trophies: 3 Give this photo a trophy
 

From album Flywheel by Metalmikejr
This is my old flywheel that i just replaced. Notice the center bolt section is gone. Any ideas on how this happens?
Browse Related Photos: flywheel, flex, plate, breather, timing, chain, gmc, beast, 1993, slx

Read comments on this photo (1 – 4 of 4)

cmoore427’s Profile Photo
cmoore427
Nov 21, 2010 at 8:41 pm
It Looks like your on the right track with the advice.
 
TexasDon’s Profile Photo
TexasDon
Nov 21, 2010 at 9:47 am
Obviously an external balanced engine. Something went out of balance. Suspect loose crank bolts. Be sure to red locktight the bolts when you replace the wheel.
 
Metalmikejr’s Profile Photo
Metalmikejr
Nov 20, 2010 at 7:16 pm
thanks. my tq bolts looked like they were loose.
 
WS6TA01’s Profile Photo
WS6TA01
Nov 20, 2010 at 6:50 pm
This could be caused if the bolts come loose and the plate starts getting a wobble to it. The torque converter could have come loose and started smacking it or the harmonic balancer could be going bad and you never know till you get it off to inspect the rubber that goes around it. High HP, a lot of stomping the pedal, or simply just age could stress it out.
 

view more