CorvairJim’s Profile Photo


Norristown, Pennsylvania
United States

baccaruda’s Profile Photo


Brighton, Tennessee
United States


1966 Chevrolet Corvair Monza


1967 Plymouth Barracuda Fastback

“Karin's 5.0 Eater”

Photo of: 1966 Chevrolet Corvair
Photo of: 1967 Plymouth Barracuda

Head to Head


About “"Ashley"”

Back in 2000, I had the misfortune to have to take a prescription that meant I couldn't drive. I sold the daily car I had at that point (one plain-Jane black 5-speed Cavalier coupe - a transportation appliance at best). A couple of years went by, and I changed doctors. The new guy prescribed something different for my condition, so I needed wheels once again. I could: A) spend $4,500 on a cheap used car that would just blend into the woodwork or, B) Find a really decent Corvair set up the way I like it. Now THAT car doesn't blend in. I found this '66 Corvair in Denver, CO, on eBay. The engine had been rebuilt by a nationally-known Corvair specialist shortly before the previous owner put it into storage for about ten years. It came out of the rebuild capable of putting 220 horsepower down to the pavement. Not bad for 164 unblown, carbureted cubic inches! It also had new tires all around. I won the auction, and flew out with my wife to drive it home. A fantastic road trip, and it cost half as much as shipping it would have. It became my daily driver for the next three years, until, in late '05, I had it in for state inspection at a friends Corvair restoration shop. While it was up on the lift, I got to see just how little rust the car had underneath. I decided at that point that it had seen its last winter of Pennsylvania road salt! It is now my nice spring day car, and a pleasure to drive. It still draws attention wherever I go with it.

UPDATE: I had to sell my beloved Ashley in August of 2009 due to the nation's lousy economy. My overtime had gone away and and my wife lost her job due to a work-related disability that they refused to accept responsibility for, so we just couldn't justify the expense of nearly $100/month to insure the third car in a two-driver household. Our mortgage was a couple of months behind, so sadly I took a friend up on his standing offer on her. As promised, he has given her the complete cosmetic restoration she so badly deserved. Of course, she didn't need anything mechanically - I always kept her up 100% mechanically. Furthermore, he gave me right of first refusal, so if he should ever decide to sell her, I get the first opportunity to buy her back.

About “Karin's 5.0 Eater”

Found this on Ebay Dec 2005, another Canada car, came into the States through the same broker in Alberta,as my 1969 did, The Electric Garage in Red Deer ,Alberta


Specs for “"Ashley"”

1966 Corvair Monza Sport Coupe
164 C.I.D. Opposed 6-cylinder engine, air cooled.
Lemonwood Yellow paint, Black interior

Specs for “Karin's 5.0 Eater”

Was a warm 318 with 360 valves, flat tops, and a 268 cam. Now has my first enginie build in it, a heated up 340 6 bbl.


Factory Options for “"Ashley"”

(All options verified by build sheet)
140 horsepower, 4 carb engine
4-speed transaxle
Posi rear
Sport Suspension
"Mag-Style" full wheel covers
AM pushbutton radio

Factory Options for “Karin's 5.0 Eater”

P/S, P/B, 904 automatic.


Mods for “"Ashley"”

Engine rebuilt to Yenko Stinger Stage III specs - 220 net horsepower.
Suspension lowered 1 coil.
Gas shocks
Steering Dampener
Low-restriction intake and exhaust.
Full window tint.
Tail panel painted silver (like the factory did with the Corvair Corsa model).
AM/FM/CD/Stereo unit mounted under the dash - NO holes cut or drilled for the installation!
Additional gauges (Tachometer, Voltmeter, Oil Pressure, Oil Temperature)
Pennsylvania Vanity Plate "CORVA1R"

Mods for “Karin's 5.0 Eater”

.060" over (350ci), forged '68 crank, Eagle SIR rods, forged aluminum TRW 13:1 pistons with domes topped to bring compression to 10;1, Mopar purple shaft 288/288, .497 lift on a 106 LSA, Comp Cams adjustable Roller Rockers, Comp Beehive springs, Mopar 6bbl manifikd with 3 Holley 2 bbl carbs, tricked up 904 tranny by John Vincent of Performance Engineering of Memphiis. Hauls serious butt, test and tune results to be posted next spring


Photo Albums 1 – 2 of 5


Previous Photo Albums Next Albums

Photo Albums 1 – 2 of 2

Cover photo of ' 67 Barracuda album
' 67 Barracuda
Photos: 8
Cover photo of 340 Engine build album
340 Engine build
Photos: 11

Previous Photo Albums Next Photo Albums


Vote This challenge has ended!

Points for "Ashley" Total Votes Points for Karin's 5.0 Eater
85 23 30


Comments on this challenge 1 – 14 of 14

Log in to post comments.

Read comments on this challenge (1 – 14 of 14)

Log in to view challenge comments.