>

Motortopia: Where your passion parks.

Motortopia > Drive! > Articles > Tech > Building a Ford 9-Inch Rearend > DRV-1105-Currie-Lead-KS

 

Advertisement

Advertisement

Building a Ford 9-Inch Rearend » DRV-1105-Currie-Lead-KS

DRV-1105-Currie-Lead-KS

A blank gear case is torqued to the center of the rearend housing, and then axle tubes that have been cut to length are installed. These are the larger tubes to house the big bearing required for the larger 31-spline axles.

This entry was posted on Monday, June 27th, 2011 at 11:32 am and is filed under . You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Comment

You must be logged in to post a comment.