Motortopia: Where your passion parks.

Motortopia > Muscle Car Power > TECH > Installing a Pertronix Flame-Thrower/Ignitor III Ignition System > MCP-WOR-1103-PERT-PIX-27

 

Advertisement

Advertisement

Advertisement


Installing a Pertronix Flame-Thrower/Ignitor III Ignition System » MCP-WOR-1103-PERT-PIX-27

Dielectric grease is used on the boots. This will not only help with the conduction, but also will make it a lot easier to remove them off the plugs in the future. Engine heat tends to make them fuse to the posts.

Dielectric grease is used on the boots. This will not only help with the conduction, but also will make it a lot easier to remove them off the plugs in the future. Engine heat tends to make them fuse to the posts.


Leave a Comment

You must be logged in to post a comment.