Filtered Content: This photo may not be appropriate for work.

Well I finished channeling the other side of the frame, the passenger rear. Also went to ACE Hardware for some washers and welded those back in the three body mounts that were shot. Now I'm boxing the open 'C' section of the frame (added pics to the 'featured' album). Couldnt find any 4 inch wide steel so I had to settle for 3 inch and bent the lower lip of the frame up to fill the gap. Actually think this is a better route to go and may make the area more ridgid than just welding a piece in without the bend. Anyway should have this done this weekend which will leave the only thing left to do is clean and paint (POR-15) it. Pretty happy with how things are moving along. Just have to keep plugging along one step at a time.